To Flash IT FW to your 1068E Controller
----------------------------------------
***MAKE SURE the JPA2 is OPEN = NOT 1-2 & NOT 2-3 = OPEN***
1. Boot to DOS with the attached utility
2. At prompt, type "CLear" then press <Enter>  		//executing the CLEAR.BAT file to clear OLD FW
3. Reset system
4. Boot to DOS again with the same utility
5. At prompt, type "X7DVL3" then press <Enter>   	//executing the X7DVL3.BAT to flash new FW
6. Message will prompt for controller SAS Address,
   -->Please enter the full 16 HEX digits (this can be found on your board with "SAS***", usually near LAN MAC label)
7. Reboot system to complete task!